How do I write firmware for it to access an ISA card? If you're not sure, this project might not be applicable to your use case. In short, take a look at these pages ...

This project is a shield for the Arduino Mega 2560. It is designed to hold all the parts necessary to interface with Chrysler's legacy databus CCD, utilized in Chrysler vehicles from the late 80s to ...

The folks over at NKC electronics didn’t waste any time with this one. They sent in the MEGA shield for the Arduino MEGA. We just posted the story of the Arduino MEGA yesterday, so that was pretty ...

Developers, makers and electronic enthusiasts may be interested in a new open source sensory substitution and sensory augmentation development kit called the Cthulhu Shield. Created by engineer Joel ...

The project is to create an Arduino Mega shield which be used to control the watering of plant automatically. The project uses several sensors like LDR or "Light Dependant Resistor", thermistor and ...

The team at [2PrintBeta] required a bunch of cables, heat shrink, and braid to be cut for their customers. They looked into an industrial cable cutter, but decided the price was a little too high, so ...

Developers, hobbyists, Arduino or Raspberry Pi enthusiasts looking to combine both Raspberry Pi and Arduino systems in the same project may be interested in a new shield for Arduino created by ...

The ARDUINO IDE associated with the ARDUINO board uses specific numbering, assigning numbers from 0 to 19 to digital pins 0 to 13 and numbers A0 to A5 to analog pins. GCBasic directly manipulates the ...