Abstract: The transients associated with transient recovery voltage (TRV), reignition or restriking events can, in general, be related to either a series or parallel RLC circuit each with specific ...

Abstract: Measurement is an act or the result of evaluation between the quantity and a predefined standard. Electrical measurements are the methods, devices and calculations used to measure electrical ...

In a series circuit, resistors are connected end-to-end, so the current flows through each resistor sequentially. The total resistance in a series circuit is the sum ...

A special frequency determined by the values of the resistance, capacitance and inductance refers to the resonance in AC circuits. The resonant frequency point occurs where the inductive reactance of ...

In many systems, transmission lines drive reactive (mostly capacitive) loads. To preserve signal integrity, you should properly terminate the lines. However, the input impedance of CMOS logic ICs, for ...

In 1827, Georg Simon Ohm noticed that different electrically conductive materials did not allow an electric current to flow with the same ease. He described this behavior as “electrical resistance” ...

When resistors are connected in series, the current through each resistor is the same. In other words, the current is the same at all points in a series circuit. When resistors are connected in series ...

If you increase the voltage across a component, there will be more current in the component. Too high a voltage and the bulb will blow. If you increase the number of lamps in a series circuit, there ...