This project uses an Arduino Micro board to convert the output from an RC receiver into a two-channel joystick via USB. It specifically depends on boards that use the atmega32u4 or atmega16u4 ...

An RC receiver signal decoder using an AVR ATTINY85 microcontroller. The decoder has a 10-bit resolution for the RC receiver pulse (1ms-2ms). To resolve the PWM pulse, pin change interrupts are used ...

These types of RF modules are very popular among makers. Because of their low cost and simplicity in connections. These modules are best for all forms of short-range communication projects. These ...

It’s winter, and that means terrible weather and very few days where flying RC planes and helicopters is tolerable. [sjtrny] has been spending the season with RC flight simulators for some practice ...

I have a good background working with high voltage, which for me means over 10,000 volts, but I have many gaps when it comes to the lower voltage realm in which RC control boards and H-bridges live.

If you are an RC modeller, then this circuit is for you! The compact RC Switch let you turn something on and off from a regular R/C channel. The device is powered entirely by the receiver, drawing ...

Abstract: Event-driven wireless sensor networks (WSNs) usually operate under light traffic load. However, when an event is detected, a large number of packets may be generated. A MAC protocol designed ...

Abstract: A crosstalk compensation (XTC) receiver is proposed for a single-ended four-level pulse amplitude modulation (PAM-4) signaling DRAM interface. The receiver compensates for the crosstalk from ...